Used Leica ICR70 5 Robotic Total Station Kit w/ CC200 Tablet & AP20 Tilt Pole. This kit includes an iCR70 Total Station which is primarily used with Concrete & General Contractors, Mechanical, Plumbing and Electrical Trades for Layout in buildings/structures. The iCR70 is one of the total stations in Leica’s line of iCON total stations and is completely Calibrated. This kit also includes a NEW Leica CC200 Panasonic Rugged Tablet with iCON Build Software. Leica’s all new AP20 tilt kit has been added to this kit, allowing accurate layout, without needing to level the prism rod. Call for more information. 1 – Leica iCR70 5 Robotic Total Station. PowerSearch, ATR, Reflectorless R500 EDM. Accuracy: Approximately 5/32 at 500 ft. 250m/820ft Reflectorless Range. 1 – Leica MPR122 360° Prism. 2 – Leica Li-Ion GEB222 Batteries. 2 – Leica Single Bay GKL311 Battery Chargers w/ Power Supply. 1 – Leica Total Station Transport Case. 1 Year iCR70 Basic CCP. 1 – New Leica CC200 10 Panasonic Rugged Tablet. Leica iCON Build Software Installed 1 – Leica Tablet Holder 1 – Leica GHT63 Pole Clamp 1 – Leica Charger 1 – Hard Transport Case. 1 – New Leica AP20 AutoPole. Targeting ID, Tilt Compensation, and Auto Rod-Height Detection 1 – CCD18 ICR Handle Upgrade 2 – Leica Li-Ion GEB321 Batteries 1 – AP20 Holding Case 1 – Leica AP20 AutoPole Rover Rod – Model: CRP5. 1 – SECO Trimax Tripod. 1 – SECO Bipod. Condition: In great used condition, fresh calibration! Layout lines for footings or chalk line for formwork on foundation. Layout points on blinding layer such as pipe insert or cut-outs before pouring concrete. MEP layout of hanger locations for HVAC and duct work, inserts and slits for sheet metal work. Fully automatic layout routines of points on floor or ceiling and lines for pipe wall penetrations.